Indførelse af produkter

Sammenlignet med andre modeller af gearboxs, den (J) ZQ Series ejer funktionerne i lille måling, stort kapacitet belastning, høj effektivitet og lavt volumen af ​​støj. Bruges i kraftige industrielle maskiner, produkterne er fremragende til at reducere produktionen hastighed og forstærke output drejningsmoment. I den fase af operationen, vil produkterne viser træk pålidelig stabilitet, som stammer fra gearene med produktionen forarbejdning af caburization og bratkøling.

Parametertabel af (J) ZQ

figur dimension og tabel af (J) ZQ serie produkter

Brug og vedligeholdelse

(1) The lubricating oil should be filled into the oil tank of the  housing which is between the two oil screws; when the

filling is finished, the reductor could run with load upon the only condition that the stability of operating is confirmed

efter at udstyret kører uden belastning i et stykke tid.

(2) The suitable brand of the lubricating oil: 150 # industrial gear oil being used in the summer 120 # industrial gear oil

being used in the winter; if the industry gear oil above are in lack of, both the 50# gear oil in summer and the 40# gear

olie om vinteren kan bruges i stedet.

(3) The inside of the reductor should be washed once at least within the first six months after it being used and then

smøreolien skal genfyldes.

(4) The reductor under the circumstance of normal operation should be maintained regularly. According to the

driftsbetingelser og konkrete situationer, bør en grundig vedligeholdelse gennemføres hver 6. til 12. måned.

Below come the details of the maintenance: Open the cover board of the peephole, then check the state of friction of

every gear. The lubricating oil should be checked carefully, if the emulsification of the lubricating oil is being

discovered,  the whole emulsion oil must be drained out and the gears should be washed by light oil, finally refill the

huser den nye olie.

If the reductor doesn’t restore to work right away, then the oil  extractor has to operate 10 minutes at least which

forsikringer den smørende film bliver opstod på overfladen af ​​gear og lejer på reductor.

(5) If the bearings are lubricated with the grease, the type ZL-3 should be used in the summer and the ZL-2 lithium grease should be used in the winter, the grease should be refilled every six month.